Dominator Precast

Precise Forms Dominator Forming System

Gang forming with the DominatorThe Precise Forms Dominator System gets its name from the fact that it dominates any project with speed while producing a quality product. This system can be quickly hand set or gang formed for rapid setting and stripping without the need to add additional hardware.

Create Flatter Walls

Standard siderail vs. Dominator Siderail. The life of this form will out perform its nearest competitor. The Dominator receives very few hits with a hammer because the form locking device is separate from the form itself. The locking device is located at the back of the side rail. The load point of the tie system has been moved as far from the load as possible; 2 1/2” on the dominator as compared to a standard flat tie form of 13/16”. This creates less vertical deflection, metal fatigue, and flatter walls. The Dominator's design creates tighter joints preventing concrete from leaking between the forms which keeps the forms cleaner and reduces labor time.

Dominator VS. Plywood

Cast in place concrete homes.When comparing the Dominator system to 24" wide plywood systems, you will find the performance of the Dominator to be superior on many levels. The accessory requirements are a minimum of 33% less than most plywood systems and the down time for refacing is a thing of the past. The aluminum form provides value when the form is to be sold or traded. With a simple maintenance program the Dominator will provide many years of quality service with a reduced cost per pour.

Gang or Hand Set

The system can be gang or handset much like any many other forming systems, therefore it is the best of both worlds in a single form. This form is 2 1/2" thick rather than a standard aluminum form at 2 1/8" thick, adding to the overall strength of the form. The load point is 2 1/2" from the face rather than the typical 13/16" on the standard flat tie system.

Taper Tie

Taper Tie System.The Dominator utilizes a Taper Tie System to provide greater form support creating flat, straight walls for concrete homes, commercial projects, retaining walls, precast, or any number of various project designs. The Taper Tie requires fewer ties per joint and is reusable thus reducing long term wall tie costs.

Taper Tie Plug

Taper Tie Plug Mold. Taper Tie Plug Mold with concrete plug.

The holes that remain from the Taper Ties are sealed using tapered plugs. The plugs can be molded with excess concrete on site creating minimal color variation in the wall or they can be created in advance to save time. The tapered plug is coated with a water proof adhesive and placed in the holes of the wall to create a water tight seal.

Dominator Forming System used in Precast

For additional precast information please visit us at Precise Precast Forms.