|
 The Dominator Forming System provides an
alternative to typical flat tie forming systems. It produces flat, straight walls with
little or no visible form seams making it ideal for commercial and international
applications. No special equipment or gaskets are required which can wear out over time.
Window and door openings are cast in place simultaneously with the walls and ceilings.
Few tools are required with the Dominator Forming System
which allows for easy training of unskilled labor. The system can be hand set or ganged
without additional accessories allowing for quick form placement and removal, saving both
time and money. The taper ties are easy to remove and are reusable. The tie holes are
plugged to create a water tight seal.
With reasonable maintenance the life of this form will out
perform its nearest competitor. The Dominator incorporates a unique factor, that being a
form that receives very few hits with a hammer. This due to the form locking device is
separate from the form itself and is located at the back of the side rail. The only
aluminum forming system to make this claim and perform with increased strength. The load
point of the tie system has been moved as far from the load as possible, 2 1/2” on
the dominator as compared to a standard form of 13/16”. This lends itself to less
vertical deflection, metal fatigue and flatter walls.
 When comparing the Dominator system to
most plywood system you will find the performance of the Dominator to be superior on many
levels. The accessory requirements are a minimum of 33% less than most plywood systems and
the down time for refacing is a thing of the past, as it is not a part of the
Dominator’s future. The inherit value of an aluminum form provides some value when
the form is to be sold or traded. With a simple maintenance program the Dominator will
provide many years of quality service with a reduced cost per pour.
 Pitched roofs and flat decks are easily
created when the Dominator Forming System is used in conjunction with the Precise Ledger
System.
 The Precise Ledger System enables the
contractor to form and pour the walls, beams, columns, and deck in one continuous pour.
The Precise Ledger System has been utilized very effectively both nationally and
internationally, as well as in the earth sheltered and underground home industry.
  The Eliminator Forming System works in
conjunction with the Dominator Forming System allowing the contractor to pour against an
existing building with only 2 3/4" of clearance. This allows the contractor to place
more homes in limited spaces or pour those single formed walls.
|
